overhead router mode to roundover some boards.
Most of the images in the manuals show a fence setup which places the fence
behind the bit with feed from left to right.
However-my boards are a bit too wide to setup this way, so I am considering putting the fence in front of the bit for more table space.
The question is - as configured in the picture, is the feed direction shown on the tape the proper feed direction ?
I've tried to indicate bit rotation as well-though its hard to see on the 2nd piece of yellow tape
Is there a better way to configure the setup for this operation ?
It feels reasonable on a test board-though i haven't tried feeding from the other side.
About midway in this thread-BuckeyeDennis showed diagrams which would indicate that my setup is ok, but Ive confused myself by moving the fence to the opposite side