JW727 wrote:I just bought and old shopsmith. It came with a scrollsaw attachment. Today I was messing around with it and went to attaching the scroll saw for the first time. There are two drive pins on the side of the headstock. The only one I can get too line up with the saw is labeled "only use this high speed with jointer or sprayer". Do I connect the saw to that one!? I would need extensions for the posts and the table would be at about 5.5 feet high if I were to line it up with the other drive shaft. Thanks in advance
That preceded the creation of the scroll saw.
The scroll saw does
connect to the lower idler(aux) shaft.
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E(SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange