phone  (937) 890-5197

Shopsmith Forums

%nbsp;

2 posts • Page 1 of 1

Lathe steadyrest 2nd attempt

#259621 by STB » Tue May 14, 2019 9:21 pm

Some time back I decided I needed a steady rest to stabilize some spoon handles I was turning. The design was ok but didn't preform very well and was awkward to use. (first picture) For my next attempt I went with a more traditional design. It doesn't work very well with the universal tool rest base. (see Picture 2 & 3) So if anyone has any good ideas I could sure use a new approach. I was thinking about making the base of the steady rest startle the universal base from side to side as apposed to the front to back approach I am using.
107 (800x600).jpg
107 (800x600).jpg (368.7 KiB) Viewed 756 times
100_0239 (800x589).jpg
100_0239 (800x589).jpg (336.98 KiB) Viewed 756 times
100_0238 (800x600).jpg
100_0238 (800x600).jpg (348.28 KiB) Viewed 756 times

---

Glenn
I create problem solving challenges and opportunities for design modification, not mistakes.

SS 520 born 04/16/03, Power Station mounted Band saw , Scroll saw, Jointer, Belt sander, Overarm router, SS Sawsmith 2000, dedicatedted Mark V drill press, DC3300, SS Maxi-clamp system, Shopsmith woodworking bench

Post a reply  Reply with quote 

Re: Lathe steadyrest 2nd attempt

#259638 by JPG » Wed May 15, 2019 1:34 am

I think the first approach would work better with smaller od bearings that are more towards the back so as to support rearward pressure. (especially with small od spoon handles).

#2 is very nicely done, but would tend to get in the way.

---

╔═══╗
╟JPG ╢
╚═══╝

Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E(SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange

Post a reply  Reply with quote 

Who is online

Users browsing this forum: No registered users and 32 guests

Board indexDelete all board cookies

Welcome to Shopsmith. Please fill in this form and we'll send you more information about the Shopsmith MARK 7 and other woodworking topics.

Subscribe to our mailing list

* indicates required