Thank you very much, Nick.
This does the job. The only thing it lacks is information on the relay and I have gotten that from the component manufacturer (NTE Electronics).
This will allow me to confirm that I have built the wiring harness correctly. Now I may have the nerve to connect my new motor to the harness.
Up until now, I have had the motor installed but it is not reversible. That is to say, I have installed it to support the saw mode only (CCW rotation of the motor).
Thanks again. I especially appreciate your effort, knowing how very busy you are.
It is service like this that makes Shopsmith stand apart from all the others.
"Making Sawdust Safely"
Sent from my Dell XPS using Firefox.