It doesn't look like you have a dust port attached. Does the bandsaw fill up with sawdust with the bottom sealed up?
Search found 112 matches
- Fri May 03, 2024 5:48 pm
- Forum: Maintenance and Repair
- Topic: Bandsaw upgrade
- Replies: 10
- Views: 458
Re: Bandsaw upgrade
- Thu May 02, 2024 4:51 pm
- Forum: Maintenance and Repair
- Topic: Bandsaw upgrade
- Replies: 10
- Views: 458
Re: Bandsaw upgrade
How did you get the flat base of the port to seal across the ridge in the plastic bandsaw cover?
- Thu May 02, 2024 4:34 pm
- Forum: Maintenance and Repair
- Topic: Bandsaw upgrade
- Replies: 10
- Views: 458
Re: Bandsaw upgrade
Correction: I may have to try this. My 2 1/2" port *isn't* doing much when I resaw.
- Thu May 02, 2024 4:33 pm
- Forum: Maintenance and Repair
- Topic: Bandsaw upgrade
- Replies: 10
- Views: 458
Re: Bandsaw upgrade
I may have to try this. My 2 1/2" port is doing much when I resaw.
- Thu May 02, 2024 12:52 am
- Forum: Maintenance and Repair
- Topic: Bandsaw upgrade
- Replies: 10
- Views: 458
Re: Bandsaw upgrade
Is that a 4” flange? Must do a much better job of catching the sawdust that otherwise falls through the slot on the bottom of the bandsaw.
- Wed May 01, 2024 5:29 pm
- Forum: Community
- Topic: Share your Magna memorabilia!
- Replies: 362
- Views: 2512452
- Wed May 01, 2024 5:10 pm
- Forum: General Woodworking
- Topic: Anyone making a Mother's Day gift?
- Replies: 5
- Views: 234
Re: Anyone making a Mother's Day gift?
Nice. How did you make the square through mortises for the handle ends? Large drill bit, then squared up with chisels?
- Mon Apr 29, 2024 7:30 pm
- Forum: Community
- Topic: Omaha Shopsmith Users Group
- Replies: 8
- Views: 9316
Re: Omaha Shopsmith Users Group
I'm impressed that you were able to round up 10 Shopsmith owners for regular meetings in the Omaha area. I'm not sure we could do as well here in Dallas/Fort Worth. Were any of you affected by the recent tornados in the area?
- Sat Apr 20, 2024 3:55 pm
- Forum: Woodworking Tool Review
- Topic: Universal Lathe Tool Rest min spindle length
- Replies: 7
- Views: 1734
Re: Universal Lathe Tool Rest min spindle length
Something to know about my Mark 7 with the Lift Assist is the bracket mounted to the Way Tubes is about 1/2" away from the Bench End to allow space to reach the Double Tilt End Lock Knob. If yours is tight against the Bench End the space between centers will be that 1/2" less. Without a L...
- Tue Apr 16, 2024 11:12 pm
- Forum: Woodworking Tool Review
- Topic: Universal Lathe Tool Rest min spindle length
- Replies: 7
- Views: 1734
Re: Universal Lathe Tool Rest min spindle length
Thanks Russ. Would a lift assist increase this gap?chapmanruss wrote: ↑Tue Apr 16, 2024 12:49 pm I'm guessing A and B equal about 7" leaving a 3" gap but I could be off some depending on the length of A.