Shopsmith Forums

Thank you all for the response. I"m in the process of building a workshop in my back yard. When i get it done and decide what tools to put where I want them, I will give shopsmith a call to get the appropriate pulley and belt for the tool I will be using it with. Thanks again!!!!

The only number I found on the stand was on the motor. ser. no. 7B84 model S48J4A3. This is a power stand, not a power station. The model number on the jointer is 505681 and the ser. no. is SS67749. I just got it yesterday and it seems a little slow for a jointer. I also have a belt sander, jig saw,...

I have a power stand for the jointer. My question is can I use the same stand for my other special purpose tools? I assume you can by changing the pulleys. I can not find the order numbers for the different size pulleys.

My shopsmith is twenty seven years old and I tightened the eccentric bushing a little to tight and snapped off the piece the bolt goes through. (do not over tighten). Can this piece be welded or reattached in some way? I ordered a new headstock and it runs a lot quieter than the old one. I have a fe...

I'm Not Sure How You Can Find This Issue, But In The Poular Science Woodworking Projects 1987 Yearbook Is A Nice Storage Cabinet That Hangs From The Bottom Tubes Of The Mark V. It Should Also Add Some Weight For You Turners. When Turning I Just Lay My Tools On Top Of The Cabinet. You May Want To Mak...

What Are Some Thoughts Of Shopsmith Making A Riser Block For The Band Saw So You Can Resaw Up To 12"? Is There Another Manufacturer That Makes A Riser For The Shopsmith Bandsaw?