Search found 90 matches
- Sat Feb 06, 2016 10:44 pm
- Forum: Maintenance and Repair
- Topic: Speed control help; again:(
- Replies: 11
- Views: 2301
Re: Speed control help; again:(
From SS.
- Sat Feb 06, 2016 10:43 pm
- Forum: Maintenance and Repair
- Topic: Speed control help; again:(
- Replies: 11
- Views: 2301
Re: Speed control help; again:(
I put on a new belt and it's started to chew it up as well.
- Sat Feb 06, 2016 9:04 pm
- Forum: Maintenance and Repair
- Topic: Speed control help; again:(
- Replies: 11
- Views: 2301
Re: Speed control help; again:(
I've tried the above suggestions and I thank you for the replies. However, after trying them, I'm back to the original problem. The speed starts slowing down after I keep turning past the "route" setting. I'm looking for a knowledgeable repair person within 3 hours, or so, of the very NE c...
- Fri Feb 05, 2016 5:20 pm
- Forum: Maintenance and Repair
- Topic: Speed control help; again:(
- Replies: 11
- Views: 2301
Speed control help; again:(
I just put on a new drive belt. After turning the speed control to fast, turning off, and adjusting the stop screw all the way until it stops against the porkchop,the speed dial will not go any lower than drum sand. The belt is 3/4 inch from the top of the motor sheaves and the porkchop stop screw i...
- Thu Jan 21, 2016 11:44 pm
- Forum: Maintenance and Repair
- Topic: Need speed control adjustment help
- Replies: 12
- Views: 3318
Re: Need speed control adjustment help
Yes, sorry.
- Thu Jan 21, 2016 10:40 pm
- Forum: Maintenance and Repair
- Topic: Need speed control adjustment help
- Replies: 12
- Views: 3318
Re: Need speed control adjustment help
So the control was on slow when I dismantled the SS. What steps do I use to reinstall the belt?
- Thu Jan 21, 2016 9:41 pm
- Forum: Maintenance and Repair
- Topic: Need speed control adjustment help
- Replies: 12
- Views: 3318
Re: Need speed control adjustment help
JPG, I bought the first one:)
- Sun Jan 17, 2016 9:28 pm
- Forum: Maintenance and Repair
- Topic: Need speed control adjustment help
- Replies: 12
- Views: 3318
Re: Need speed control adjustment help
Sorry for the long delay. I just got around to tearing down the SS. The belt was half "eaten" and required a dismantle to clean and relubricate everything. It looks like the control sheave was sticking, possibly a secondary problem caused by rubber gumming up the sliding. I think the main ...
- Wed Nov 18, 2015 8:53 pm
- Forum: Maintenance and Repair
- Topic: Need speed control adjustment help
- Replies: 12
- Views: 3318
Re: Need speed control adjustment help
Both speed controls will increase speed until you get to the "Saw" setting and then start slowing down incremently afterwards.
- Wed Nov 18, 2015 5:56 pm
- Forum: Maintenance and Repair
- Topic: Need speed control adjustment help
- Replies: 12
- Views: 3318
Need speed control adjustment help
Hi, I am a long time lurker and occasional poster. I've restored two 1953 model Mark V's but need help adjusting the speed controls. I'm located in the NE corner of Missouri. Is there anyone in the area (I'll drive to St. Louis, if needed) that has experience adjusting these? I'm willing to pay for ...