I got this jig idea in an email from Woodsmith. It is for aligning the table in drill press mode.
Bruce
Table alignment jig
Moderators: HopefulSSer, admin
Table alignment jig
- Attachments
-
- Woodworking Tip_ Table Position Jig.pdf
- (151.63 KiB) Downloaded 2281 times
- dusty
- Platinum Member
- Posts: 21374
- Joined: Wed Nov 22, 2006 6:52 am
- Location: Tucson (Wildcat Country), Arizona
Table Alignment Jig
This is a GOOD tip Bruce. It works well with the Shopsmith Main Table (in the drill press mode). Nick did something similar to this in either a Tip or a Sawdust Session.
http://www.shopsmithacademy.com/SS_Archives/SS122/SS122_Aligning_Table_with_Chuck.htm
P.S. This is an interesting session as well; it shows how to make certain that your drilled holes are the correct depth.
http://www.shopsmithacademy.com/SS_Archives/SS123/SS123_Digital_Drilling.htm
http://www.shopsmithacademy.com/SS_Archives/SS122/SS122_Aligning_Table_with_Chuck.htm
P.S. This is an interesting session as well; it shows how to make certain that your drilled holes are the correct depth.
http://www.shopsmithacademy.com/SS_Archives/SS123/SS123_Digital_Drilling.htm
"Making Sawdust Safely"
Dusty
Sent from my Dell XPS using Firefox.
Dusty
Sent from my Dell XPS using Firefox.