phone  (937) 890-5197

Shopsmith Forums

%nbsp;

1 post • Page 1 of 1

ER10 Drive shaft reassembly

#264435 by struzik » Fri Nov 08, 2019 7:40 pm

Hi All --

I recently started restoring an ER10. I searched but couldn't find an answer to this - I have everything cleaned, painted, and ready to assemble however the quill/drive sleeve has me scratching my head (and wishing I took more pictures when I took her apart).


Originally I left the bearings in-place since they seemed to run smooth, however when I tried to put the shaft back in (as below), it got really tight. At one point I tried tapping it in and it pushed out the bearing. I'm afraid of using too much force and damaging something. Is this the correct line up?

Thanks for any help.

Attachments

IMG_20191108_175334.jpg
Original shaft prior to install
IMG_20191108_175334.jpg (210.97 KiB) Viewed 47 times
IMG_20191108_185800.jpg
Line up?
IMG_20191108_185800.jpg (215.01 KiB) Viewed 47 times

Post a reply  Reply with quote 

Who is online

Users browsing this forum: SkullsquadronX and 35 guests

Board indexDelete all board cookies

Welcome to Shopsmith. Please fill in this form and we'll send you more information and special offers for the Shopsmith MARK 7 and other woodworking topics.

Subscribe to our mailing list

* indicates required