Two Bearing Quill
Posted: Tue Feb 13, 2007 11:08 am
Other then headstock serial number, is there a way to examine the quill and determine whether it is a two bearing or single bearing quill?
A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
reible wrote:Hi,
Yes, but it does require you to remove the quill from the machine. Once you have the quill out it is a simple matter of looking in from the back side.
Have a look at the pictures here:
http://new.photos.yahoo.com/elv60504@sb ... 2316215999
The first few pictures are of the single bearing one and the last ones are of a two bearing one taken apart. You don't need to take it apart to tell but just make sure you are not tricked by the funny shaped washer.
Ed
Bill, I found that I had to change the bearings and according to markings are standard bearings 60032 (big one) and 60022C3 (small one).annbill.mayo wrote:Does anyone know the bearing number or the OD, ID and width of the second (in the middle) bearing on the two bearing quill referenced below. Thanks.
Bill Mayo