Miter Gauge and reattached it to the Shopsmith Miter Gauge (505700).
I did this because it seemed to be that the Safety Grip was much looser, on the Miter Gauge, than it had been. I was actually attempting to get the wobble out of the Safety Grip (not necessarily swap it back).
Because I could not find a way to "firm up" this assembly, I decided to mount it back on the Shopsmith Miter Gauge. Done. It fits there like I think it should and it is not wobbly.
QUESTION (for those with a V120 equipped with the Safety Grip): Does the Safety Grip mount firmly to your V120 Miter Gauge with minimal side-to-side wobble of the Grip.
- Miter Gauge by Incra with Shopsmith Safety Grip.jpg (91.45 KiB) Viewed 1115 times
- Miter Gauge 004.JPG (119.16 KiB) Viewed 1114 times
Sent from my Microsoft Surface Pro using Firefox.