Search found 34648 matches
- Sun Dec 14, 2008 4:02 pm
- Forum: General Woodworking
- Topic: Speed Control and Frightening Noises
- Replies: 33
- Views: 56058
Sheaves = Control / Drive
If you look back at Nick's post you will notice the words "DRIVE SHEAVES" when referring to 1/16 ...1/8 inch dimension below outer rim of sheaves depicted in picture....You can notice the end of motor housing!! Compare this pix to that of "CONTROL SHEAVES" in previous pix. The UP...
Farewell.....Return SOON!!!!
NICK!! Do not CHANGE too much. Thanks for past "HELP" GOOD LUCK!!!!!!!!!!
- Fri Dec 12, 2008 7:18 pm
- Forum: General Woodworking
- Topic: Rpm
- Replies: 68
- Views: 34092
- Fri Dec 12, 2008 1:34 pm
- Forum: General Woodworking
- Topic: Rpm
- Replies: 68
- Views: 34092
I like Nick's reply and would like to add another into the mix - frequency - Us that run at 50Hz have a different speed range to the USA 60Hz - divide by 60 and multiply by 50 - or just turn the darn dial to Saw! Works for me Regards Sandy in NZ Sandy!!! Are you using a motor designed to run on 60 ...
- Fri Dec 12, 2008 1:00 pm
- Forum: General Woodworking
- Topic: Rpm
- Replies: 68
- Views: 34092
- Fri Dec 12, 2008 11:08 am
- Forum: Maintenance and Repair
- Topic: Jacobs Chuck key needed
- Replies: 22
- Views: 43166
- Thu Dec 11, 2008 11:43 am
- Forum: Beginning Woodworking
- Topic: Sawblade Question
- Replies: 6
- Views: 13697
- Thu Dec 11, 2008 11:35 am
- Forum: Beginning Woodworking
- Topic: Sawblade Question
- Replies: 6
- Views: 13697