The miter bar would be the least of your problems. I called Incra a few years back to inquire about a Shopsmith edition 1000HD and they pointed out that the head is too big and would run into the blade. There's barely enough clearance with the v120 head.
If you want to run a 1000HD on a Shopsmith, buy a Miter Express and mount the 1000HD on that. Moves the head quite a bit further from the blade.
Last edited by algale on Tue Oct 04, 2016 7:52 am, edited 1 time in total.
Gale's Law: The bigger the woodworking project, the less the mistakes show in any photo taken far enough away to show the entire project!