phone  (937) 890-5197

Shopsmith Forums

%nbsp;

637 posts • Jump to page: 1 60 61 62 63 64

From the V-berth, next I jumped into the aft deck and started making mahogany dust. Lots of it.

The Boatamalan painter lost two of three big pieces of original mahogany that span the top of the helm windshield. It would have been practically impossible to make new wood match the old one, so I made all three panels from the boards I had resawn recently. I also made some corner pieces for the aft deck that I'll use to join four plywood panels.

1969 Chris Craft Roamer 46 Refit: Helm Station Mahogany

Cheers,
Q

Image

Image

Post a reply  Reply with quote 

As long as I'm working with solid mahogany in the aft deck and helm area, I figured I might as well get the panel work done, too. It's turning out really nice.

1969 Chris Craft Roamer 46 Refit: Aft Deck Mahogany Panels

Cheers,
Q

Image

Image

Post a reply  Reply with quote 

I've been ripping through the resawn mahogany boards recently. Turned another couple of rough cut boards into pretty stuff.

"progress"

1969 Chris Craft Roamer 46 Refit: Helm Station Mahogany II

Cheers,
Q

Image

Post a reply  Reply with quote 

Next I fitted the 3mm mahogany plywood to the helm bulkhead. I'm using plywood instead of veneer because it's a lot easier to work with and it's half the price of veneer.

1969 Chris Craft Roamer 46 Refit: Helm Station Mahogany II

Cheers,
Q

Way back in the beginning
Image

Last weekend
Image

Post a reply  Reply with quote 

I spent a tedious day recently pulling wire and cable from the V-berth and salon power panel all the way up to the aft deck hardtop ceiling. I have to get the wiring all done before we can install the headliner. Fortunately, this part of the job is done. Hopefully, I'll never have to do that again.

1969 Chris Craft Roamer 46 Refit: Aft Deck Wiring

Cheers,
Q

Image

Post a reply  Reply with quote 

As part of the prep for installing the aft deck headliner, I've got to get everything installed in the ceiling overhead. The wiring is pretty much done, so my next project was to make a mahogany box for the radios and fuel gauge. I ended up using the leftover mahogany boards from the resawn fascia boards I made in the aft stateroom. I have to say, it looked a bit rough on the dusty, oxidized side that was exposed to air without varnish for a decade. But once it's glued up, sanded, and varnished that's some pretty wood.

1969 Chris Craft Roamer 46 Refit: Helm Station Radio Box

Cheers,
Q

Before
Image

After
Image

Post a reply  Reply with quote 

The helm station radio box is looking good. So next I jumped on the One-Mile Ray searchlight install. The light sure looks nice rechromed and assembled. But I found a surprise in the hardtop ceiling when I went to install it.

That seems to be a pattern with this refit...

1969 Chris Craft Roamer 46 Refit: One-Mile Ray Searchlight
Cheers,
Q

The good part
Image

The bad part
Image

Post a reply  Reply with quote 

Who is online

Users browsing this forum: MSN [Bot] and 36 guests

Board indexDelete all board cookies

Welcome to Shopsmith. Please fill in this form and we'll send you more information and special offers for the Shopsmith MARK 7 and other woodworking topics.

Subscribe to our mailing list

* indicates required