I had no problem getting it reassembled but I did have to use a flat washer to eliminate the unwanted wobble.
Yes, JPG, if the post is not screwed down tight in the large aluminum block there will be some unwanted movement. That is not the movement, however, that brought this discussion to surface.
The movement that I found objectionable was the handle (the grip) wobbling on the small aluminum block.
The hold down mechanism is "loosey goosey" no matter what and it needs to be that way.
One side is flush while the other side needs a flat washer.
This video shows how much tighter the Safety Grip is after adding that single flat washer. I regret not doing this a long time ago when I first received the V120 from Shopsmith.
- The Miter Gauge Gap 001.JPG (24.35 KiB) Viewed 1044 times
- The Miter Gauge Gap 003.JPG (22.51 KiB) Viewed 1043 times
Sent from my Dell XPS using Firefox.